We offer a wide range of Melt Flow Index Tester widely used to determine the melt flow index of plastic material. This system is structured with a heated extruder tube, an interchangeable jet and a piston with dead weights. This piston is used to apply the required pressure on the material inside the carbon steel extruder tube. A Bend Heater is affixed around outer circumference of the extruder tube and is used as an effective heating material. This heater is covered with a mineral wool insulation. The extruder tube is installed with a PID controller to indicate & control the temperature. Manufactured in accordance to the ASTM D 1238 & equivalent standards, this range of testers is available in various models with different parameters.